3DIGI FLYBARLESS SYSTEM DNRS FREE SHIPPING on this item The revolutionary electronic stabilization system for flybarless (FBL) RC helicopters 3DIGI is ready to use and supports a wide range of interfaces. Connection for setup and tuning can be direct to a computer via a Micro-USB cable (user-supplied) or an Android device (using an optional external module) via Bluetooth. FEATURES Advanced 6 Axis MEMS sensor (Gyro and Acceleration) Powerful 32bit ARM Microcontrollers. Integrated R2 micropower bus supplies the internal processor, sensors, and Spektrum satellites from a minimum input voltage of 1.7 volts. Optional HC (High Current) version with dedicated power input. Built-in vibration analysis (data recording via optional micro SD card). Onboard Micro USB port for configuration and automatic firmware updates. Simple and friendly Windows-based setup Terminal. Android App. Connection for standard Bluetooth modules. Connector for standard GPS receiver (compatibility list in preparation).RC input supports all popular sum signal inputs (PPM, S-Bus, UDI, Graupner SUMD, Multiplex SRXL, Jeti EX Bus) or Spectrum satellites. Servo outputs for swashplate (4X), Tail, and Throttle. Input for RPM sensor. Status display via 2 LEDs. 3 Parameter Sets (Banks) selectable in flight Live tuning of up to 8 individual parameters in flight allows for fast tuning. Internal event Logging Micro SD slot (Micro SD card is not included) for storage of flight, vibration, and GPS data (with optional external GPS module) Auto trim for precise trimming of the swashplate and tail. TECHNICAL SPECIFICATIONS Dimensions approx.: 39.5mm x 32,8mm x 14.6mm Weight approx .: 15g - 0.52 Ounce Operating voltage: 1.7V - 9V (the minimum voltage of the servos used must be observed for trouble-free operation) Sensor: MEMS Processor: ARM 32 bit Lukas Dinger having fun with the XNOVA 4530-480KV & 3DIGI WHAT'S IN THE BOX 1 x 3Digi (Flybarless System)2 x Double-sided adhesive pads Instructions Manual (12/19/2015) NEW Installer for Terminal V2.0.0 (07.07.2017) New settings for the current firmware Several improvements and optimizations 3Digi Firmware greater than V2.0.0 required NEW Firmware V2.0.0 (07.07.2017) Hint: Save the current setup as a file with the old Terminal before the update AutoLevel/Rescue Improved control feeling filter: smoother cyclic stops combined with better responding control Initial response optimizer: helps you to find a good setting for the initial response Speed flight optimizer: Makes the helicopter smoother in speed flight passages Improved swash special mixer: allows mixing yaw to swash servos, for tandem, coax and so on Several internal improvements and optimizations Terminal V2.0.X required Android App 2.0.X required User guide V2.0.0 Jeti Integration files V2.0.0 Additional documentation is downloadable at www.3digi.de
