Warning: The HackRF Pro is a research tool and test equipment for RF systems. It is NOT a consumer-level product and has NOT been certified for consumer or commercial use. You are responsible for using the HackRF Pro legally according to RF transmission and signal processing regulations. HackRF Pro from Great Scott Gadgets is a Software Defined Radio peripheral capable of transmission or reception of radio signals from 100 kHz to 6 GHz. Designed to enable test and development of modern and next-generation radio technologies, HackRF Pro is an open-source hardware platform that can be used as a USB peripheral or programmed for stand-alone operation. Preliminary specifications: 100 kHz to 6 GHz operating frequency Tunable from 0 Hz to 7.1 GHz Half-duplex transceiver Up to 20 million samples per second 8-bit quadrature samples (8-bit I and 8-bit Q) Compatible with GNU Radio, SDR#, and more Software-configurable RX and TX gain and baseband filter Software-controlled RF port power (50 mA at 3.3 V) SMA RF connector SMA clock input and output for synchronization and triggering Convenient buttons for programming Internal pin headers for expansion High-Speed USB 2.0 with Type-C connector USB-powered Open source hardware Compared to HackRF One, HackRF Pro introduces a host of new and updated features, including: Wider operating frequency range Improved RF performance with flatter frequency response Modern USB Type-C connector Built-in TCXO crystal oscillator for superior timing stability Logic upgrade from a CPLD to a power-efficient FPGA Elimination of the DC spike Extended precision mode with 16-bit samples for low sample rates (typical ENOB: 9-11) More RAM and flash memory for custom firmware Installed shielding around the radio section Trigger input and output are accessible through clock connectors Cutout in the PCB provides space for future add-ons Improved power management HackRF Pro is open-source hardware that is compatible with existing add-ons, including Opera Cake from Great Scott Gadgets, most PortaPacks, and some enclosures from third-party providers. Design files and documentation will be released prior to the initial shipment in September. Software that works with HackRF One is already compatible with HackRF Pro. We designed HackRF Pro for backward compatibility, following the same basic architecture of HackRF One but with many small enhancements. Prior to shipping HackRF Pro, we will publish a migration guide that will show software developers how to take advantage of certain new capabilities of HackRF Pro, but out-of-the-box HackRF Pro will behave like HackRF One with superior performance. In addition to host software compatibility, our migration guide will address firmware, allowing developers to port custom firmware to the new platform and take advantage of its unique capabilities. HackRF Pro has an injection-moulded plastic enclosure. Note: USB-C cable and antenna are NOT included. ANT500 Telescopic Antenna is recommended as a starter antenna for HackRF Pro. An alternative is the shorter ANT700 Telescopic Antenna.
