Custom cutting guide. Items are made to order. See below for more information on processing time. BPA Free. Food grade PETG/PLA+ certified by both TÜV SÜD and SGS with reference to 21 CFR 175.300 of The U.S. Food & Drug Administration Code of Federal Regulations (FDA 21 CFR 175.300). Guides are made to order. Large volume orders will require additional processing time. Cleaning and Care Guide *WARNING: NOT DISHWASHER SAFE. DO NOT DROP GUIDE ON HARD SURFACES. DUE TO THE GEOMETRY OF THE GUIDE, DROPPING ON HARD SURFACES MAY RESULT IN DAMAGE AND/OR CRACKS TO THE GUIDE. 1. Wash the mold using warm water and a mild dish soap. 2. Use a soft cloth or sponge to scrub all surfaces, paying special attention to crevices. A microfiber cloth is ideal to avoid scratching the surface.3. Rinse thoroughly with clean water to remove all soap residue. To DisinfectOption A: Isopropyl Alcohol (IPA)1. Use 70% IPA, as higher concentrations can be less effective at disinfecting. The water content helps the alcohol penetrate more effectively.2. Apply to the mold with a spray or wipe.3. Maintain wetness for at least 30 seconds to several minutes, to ensure proper disinfection.4. Allow the mold to air-dry completely. Option B: Hydrogen Peroxide1. Use a standard 3–5% hydrogen peroxide solution.2. Submerge the mold or apply the solution to its surface.3. Allow the peroxide to remain on the plastic for several minutes before rinsing thoroughly.4. Rinse and dry to prevent any remaining residue from contaminating your materials. Option C: Hypochlorous Acid solution1. Use a 100-200ppm of Hypochlorous Acid solution.2. Spray/Soak the mold in the solution for around 10 minutes.3. Rinse thoroughly with clean water afterward to remove all traces of solution. Option D: Bleach solution1. Mix a diluted bleach solution following this ratio: 4 teaspoons of bleach per quart of water, or ⅓ cup of bleach per gallon of water.2. Soak the mold in the solution for the manufacturer's recommended contact time, typically around 10 minutes.3. Rinse thoroughly with clean water afterward to remove all traces of bleach. StorageStore molds in a clean, dry area after disinfecting to prevent recontamination. Processing and Production TimeItems in stock will be shipped with 1 day. Items made to order will require additional production and time. For order requiring more than 4 units, please email [email protected]. ShippingFor orders with more than 8 units, please email [email protected].
Related
Related
Related
Related